Harley Davidson Grip Removal

If you appreciate this free video consider supporting us by purchasing these grips or any other items through our Revzilla Affiliate Link.

Harley davidson grip removal. Remove the left grip. To remove the grip a slight tug may be necessary to release the index pins in the grip from the receptacle in the seal cap. Upon removing the grip check the location of the seal cap.

How do you remove tracker grip on Harley Davidson. Remove the grip by carefully cutting it away from the handlebar using a sharp blade or knife. Reinstall the switch housing by tightening the T25 screws.

Once aligned remove the grip and apply adhesive to the inside of the grip. Remove the end cap from the existing left handlebar grip if equipped. Once the grip is off wrap the string around your handlebars and use a ruler to find the diameter of your handlebars.

Be careful and try a heat gun or hair dryer enough to loosen the contact cement you used on the grip and try to rotate the grips. Attach the throttle open and close cables by inserting the ferrules over the ball ends and into the new grip. Remove the old throttle grip from the handlebars and clean the area it covered.

The left grip is generally glued to the bar and some of the 1996-newer grips are clamped within the left control button pod or both clamped and glued. Slide the new grip onto the handlebar and check that the flanges at the end of the grip line up with the channel in the switch housing. You can change your hand grips for comfort looks or both.

You can also use compressed air to try to break the adhesive bond. To remove the old grip not caring whether you destroy it cut off the very end of it. No additional cost to you but if you click through and make a purchase we.