Harley Davidson Heated Grips Fuse Location

The connector at the end of the wire harness on the hand gripsleeve must extend past the left end of the handlebar.

Harley davidson heated grips fuse location. If you follow the rudder hose that exits the rear right side of your oil tank it leads to the bottom of the frame under this is the oil plug. NOTE Make sure that the handlebar surface is smooth dry and thor-oughly cleaned of all dirt. I guess the same fuse coverlabel is used on both models.

Select the correct ring terminal 4 5 or 6 from the kit to fit the silver terminal stud with the red wire on the circuit breaker. Hi Kelly Under your left side cover you will find a fuse block containing headlamp ignition lighting instruments brakes cruise radio memory radio power accessory etc fuses. Two grips in parallel as shown in our wiring diagram and applying 12 volts using a car.

Sometimes I find mine just slightly on from me having bumped it with my hand or someone admiring the bike and putting finger where they shouldnt. That circuit also drives optional heated hand grips. You will need to remove the fuse block cover to access these fuses.

They have worked great thus far and are still technically workin. Route the heated hand grip wires over to the Electrical Connection Harness. Once you have the connector loose you can crimp your wire to it using a Molex crimper on the wire and a different molex crimper on the outer shielding.

This repair will work on all of the following new generation grips because the current part numbers for the replacement BMW heated grips are the same on all of the following bikes. Harley-Davidson heated handgrips just stopped working. I currently ride a F800GS and recently had a left heated grip failure but I managed to open up the sealed grip and get to the element to fix it myself.

Grips have been thermally mapped to provide a more uniform heat and are designed to achieve a maximum operating temperature approximately 20 Fahrenheit warmer. On the Harley Davidson Touring the fuse box is often located under your seat or sometimes under the left side cover. Hold the right side heated hand gripthrottle sleeve and wire harness in position along the outside of the handlebar as if the assembly were installed on the handlebar.